Marko Mäkelä wrote:
>> Are there any standard connector housings that could house both the
>> cassette port connector (single or double sided card edge connector with
>> 6 contacts at 3.96 mm spacing) and the "IBM PC/AT standard RS-232" DB-9
>> connector, and the circuit board?
>There are those Sub-D adaptor housings, that have a space for a small
circuit
>board. The one that would fit the two connectors best is the dual 9pin
Also a 25-9 adaptor housing could possibly be used, giving a little more
circuit board space.
Has anyone seen a DB15 to DB9 adaptor housing? I'm looking for something
like this for another idea.
- nick
PLEASE TAKE NOTE:
The contents of this email (including any attachments) may be
privileged and confidential. Any unauthorised use of the contents
is expressly prohibited. If you have received this email in error,
please advise us immediately (you can contact us by telephone
on +61 8 9441 2311 by reverse charge) and then permanently
delete this email together with any attachments. We appreciate
your co-operation.
Whilst Orbital endeavours to take reasonable care to ensure
that this email and any attachments are free from viruses or other
defects, Orbital does not represent or warrant that such is explicitly
the case
(C) 2000: Orbital Engine Company (Australia) PTY LTD and its
affiliates
Message was sent through the cbm-hackers mailing list
Archive generated by hypermail 2.1.1.