Re: 8296 Execudesk disk

From: Andre Fachat (a.fachat_at_physik.tu-chemnitz.de)
Date: 1998-10-06 12:44:18

Ruud Baltissen wrote:
> 
> I lately repaired a 8296 by replacing its PLA-chip. But it starts up in the 
> monitor mode. Is this normal? If not, what should I see? 

Where did you get the PLA equations? Or did you use a PLA from another
8296?

Andre

-- 
Email address may be invalid. Use "fachat AT physik DOT tu-chemnitz DOT de"
------Fight SPAM - join CAUCE http://www.cauce.org------Thanks, spammers...
Andre Fachat, Institute of physics, Technische Universitšt Chemnitz, FRG
		http://www.tu-chemnitz.de/~fachat
-
This message was sent through the cbm-hackers mailing list.
To unsubscribe: echo unsubscribe | mail cbm-hackers-request@dot.tcm.hut.fi.

Archive generated by hypermail 2.1.1.