Marko Mäkelä wrote:
> Are there any standard connector housings that could house both the
> cassette port connector (single or double sided card edge connector with
> 6 contacts at 3.96 mm spacing) and the "IBM PC/AT standard RS-232" DB-9
> connector, and the circuit board?
There are those Sub-D adaptor housings, that have a space for a small circuit
board. The one that would fit the two connectors best is the dual 9pin
adaptor, but it's circuit board space is *very* small. Its size would be
something like 15mm wide and 40mm long. The card edge connector should also
fit pretty well, if the space that is normally used for the D-Sub mounting
holes is used as board space, and then the six contact are soldered there.
Nicolas
Message was sent through the cbm-hackers mailing list
Archive generated by hypermail 2.1.1.