Hello! Julian Perry wrote: > Have you checked the height of this against the "Low profile" (as > opposed to Breadbin) cases? There's significantly less room in those > cases. Yes, I did :-) It fits perfectly to a milimeter - the DIP32 Flash chip on the upper board just touches the vent holes in the top cover. And that is including DIP24 and DIP28 sockets soldered instead of the original ROM chips. The only downside is that the upper board must be moved about 3 centimeters towards the rear, so that it does not interfere with the keyboard mounting. That means that the lower board must be bigger to move the connectors in that direction. But then, it must be bigger anyway to accommodate an additional 7400 chip that translates the CS line of the ROM/KERNAL chip and its A13 line into proper KERNAL_CS and BASIC_CS lines the upper board expects. Regards, Michau. Message was sent through the cbm-hackers mailing listReceived on 2013-07-22 10:00:06
Archive generated by hypermail 2.2.0.