On 2012-10-08, at 20:16, silverdr@wfmh.org.pl wrote: >> You can run an EPROM with _CS and _OE tied LOW and change the address inputs. After tAcc, you will see the the expected output on the data lines. That's how the PLA-replacement using a 27C512 works. > > When I ground both lines, the machine doesn't boot at all. When I do it once it already booted, then it crashes at the characters get garbled. When I now untie those lines from GND, the characters get clean again but of course machine doesn't run anymore. Yeah - disregard my ignorance here.. -- SD! Message was sent through the cbm-hackers mailing listReceived on 2012-10-08 20:00:38
Archive generated by hypermail 2.2.0.