>>>>> "Andre" == Andre Fachat <a.fachat@physik.tu-chemnitz.de> writes:
MV> Hi, I just received a replacement 6525 so now I have a working
MV> IEEE-488 interface. I have a few questions that I hope someone
MV> could answer:
MV> There's an 8K ROM in the interface that I'd like to read out, but
MV> it gets swapped out. How do I swap it in? One of the 6525 registers
MV> at $dfxx i guess, but which one?
Andre> If you have an original CBM IEEE488 interface, you can use my
Andre> new kernal.
I do, so I guess your kernal will be yet another one to put in my SX.
I wonder how many EPROMs I can stack on top of eachother :)
Andre> But I have the EXROM/GAME lines disconnected from the
Andre> module.... :-)
I'll probably install switches on my cartridge port instead.
MV> Is it possible to use IEC devices together with IEEE devices? The
MV> 1541 on device 8 and the 1581 on device 9 just give me a device not
MV> present error. Currently there's nothing plugged into the IEEE
MV> interface since I haven't soldered a cable yet.
Andre> You can map any of the drives to either serial or parallel IEC
Andre> bus.
How do I do this?
Andre> The Software copies itself from the ROM area to $C*** (pretty
Andre> unusable...)
Well, it makes it easier to patch :)
Andre> and then swaps out the ROM.
Ah, OK.
--
___ . . . . . + . . o
_|___|_ + . + . + . . + + Per Olofsson
o-o . . . o + MagerValp@Goth.Org
- + + . http://www.cling.gu.se/~cl3polof/
-
This message was sent through the cbm-hackers mailing list.
To unsubscribe: echo unsubscribe | mail cbm-hackers-request@dot.tcm.hut.fi.
Archive generated by hypermail 2.1.1.