Re: 27C512 EPROM in a C128

From: Nicolas Welte; address is valid for replies (Re:) only! (
Date: 2003-01-02 16:06:17

Niklas Ramsberg wrote:
> Hej allihopa!
> OK, so I've read what little info I could find on this subject and come
> to this conclusion: If I bend the A15 pin on the 27C512 out of the
> socket and connect a switch between A15 and ground and a 4.7kOhm
> pull-up resistor between A15 and VCC, I should be able to switch between
> the lower and higher 32K in the EPROM, right?

Yes, this will work fine.


PS: I will now upload the 2364 adaptor construction page. It became much more 
complicated than I wanted it to be, but I hope it helps anyways:

       Message was sent through the cbm-hackers mailing list

Archive generated by hypermail 2.1.4.