CMD Smart Mouse wires

From: Terry Raymond <*traymond160_at_gmail.com*> Date: Wed, 30 Jul 2025 13:32:03 -0600 Message-ID: <CAJ+D7=O_cYFwDMGUt8YJsMRh4FbNwhq8FvNwV5EqJMcbjDttvg_at_mail.gmail.com> · traymond160_at_gmail.com

This is Terry Raymond

Hi has anyone here ever owned a CMD Smart Mouse?
the problem with this mouse was it had no Joystick wire restrainers so the
wires wiggled
(inside the mouse case) so the wires after a time would break right at the
solder joint,
more to the front part of the PCB.

I of course own one and yeah all the wires broke so I have no idea where
they all
belong or connect to on the PCB.
If anyone else owns a Smart Mouse if you could possibly do me a favor,
please:
take the case apart and again towards the front part of the PCB is where
the Joystick
wires solder down,  take a picture of that area, again a very closeup
picture.
Or if you have a scanner even a closeup scan would probably work.
Only Im going to use an Atari 2600 joystick cable, the aftermarket Joystick
cable CMD used
the wires were hair thin and a pain to mess with.

  This mouse worked fine just the wires Im not sure of, but this is the
only way I could figure this out so I appreciate any help with this.

email me the pictures to
traymond160_at_gmail.com