Re: C64C case production molds resurfaced

On 2015-03-09 22:19, Anders Carlsson wrote:


> snap on clips. I believe the first type of case mounts the keyboard into
> the top half of the case with screws, and the second type has a design
> where the keyboard lies flat on top of metal shielding, not attached to
> the top half.

There were three variants of the kbd mounting.

> It seems the molds in this case belong to the first series of C64C
> cases. I don't recall if the motherboard/keyboard from a newer
> generation C64C perfectly fits in the older shell, but let's hope it does.

Yes, keyboard assys and mainboard assys were all mechanically 
interchangeable. The worst keyboard mount was the one with latches 
rather than screws. The keyboard there had a tendency to get lose and 
fall down easily.

-- 
SD!

       Message was sent through the cbm-hackers mailing list