Hallo allemaal, > Maybe it goes to the vic 20 joystick port? That was my first thought as well. But GROUND goes to pin 2, not pin 8. OK, one could still make a cable that connects the various digital pins of the joystick to the digital ones of this connector. But what goes to what ??? And the next question: how is the whole to be operated, what commands etc. ??? I could disassemble the ROM and analyse it but to be honest, I don't think that it will be worth the trouble at all. If I really need something to be printed on a Centronics printer, there are enough other possibilities: I have several IEC-Centronics convertors, programs that turn the Userport into a Centronics port and I thougt SpeedDOS, JiffyDOS and/or Exos V3 support Centronics over the Userport as well ??? I will put it in the drawer "unknown hardware". -- Kind regards / Met vriendelijke groet, Ruud Baltissen www.Baltissen.org Message was sent through the cbm-hackers mailing listReceived on 2014-04-24 18:00:03
Archive generated by hypermail 2.2.0.