Re: Commodore 64 cartridge cases

From: Michał Pleban <>
Date: Fri, 15 Nov 2013 16:05:23 +0100
Message-ID: <>

Anders Carlsson wrote:

> It is the same case! The C64 circuit board fits a bit tight inside the
> case, but it works. Try it if you can!

I just did. The board fits indeed, but the positioning pin is moved a
bit towards the back (about 3 mm) so the edge connector on the board
just barely sticks out of the case.


       Message was sent through the cbm-hackers mailing list
Received on 2013-11-15 16:00:04

Archive generated by hypermail 2.2.0.