On 2013-11-15, at 14:32, Michał Pleban <lists@michau.name> wrote: > Hello! > > I am looking for ideas where a significant number of Commodore 64 > cartridge cases could be obtained. > > I saw that one site in Germany sells them for about 6 EUR. This is an > outrageous price :-) Well... and the quality is not really top-shelf either. > I think it would be beneficial for the community if there was a supply > of cartridge cases in acceptable prices. However, I am struggling to > find a source where these could be obtained. I downloaded the technical > drawings from the aforementioned site and called about 20 Polish > companies that do injection moulds and not one seemed to be interested :-( The problem is that for high quality output you need high quality tooling process. Only then off-tool results are better than a 3D printed ones ;-) Those things cost. I doubt you can substantially bring the unit price down unless you produce (and sell!) (tens of) thousands of them so that you can have your tooling at least broken even. -- SD! Message was sent through the cbm-hackers mailing listReceived on 2013-11-15 15:01:26
Archive generated by hypermail 2.2.0.