On 5/31/2011 2:29 AM, Nils Eilers wrote: > > But CF cards would be first choice, since they can operate at 5V, give you parallel 8 bit wide access and are very easy to connect with any 8 bit micro. A lot of homebrew projects are on the net, where people have connected them succesfully to any 8 bit CPU. You could take one or some of them as a starting point for your 6502 based CF project. > > But this is a complete different project and has nothing in common with petSD. Actually, it's not entirely. uIEC/IDE implements CF card support, and the code is in sd2iec. Check out the uIEC config. You'll see it include the ATA code. So, by recompiling with ATA support, you can enable petCF :-) Jim Message was sent through the cbm-hackers mailing listReceived on 2011-06-01 03:00:21
Archive generated by hypermail 2.2.0.