Re: Replacing the drive mech in a CMD HD

From: Glenn Holmer <*shadowm_at_lyonlabs.org*> Date: Mon, 02 Nov 2009 04:57:03 -0600 Message-ID: <1257159423.2542.9.camel@cenbe> · shadowm_at_lyonlabs.org

On Sun, 2009-11-01 at 18:34 -0600, Jim Brain wrote:
> Glenn Holmer wrote:
> > I have the drives set as SCSI ID 0, and have tried all combinations of
> > putting termination resistors on the drive and enabling term. power, and
> > using a plain 50-pin SCSI cable and one that has a terminator in it.
> >
> > Can anybody suggest where to go from here?
> >
> >   
> Another SCSI ID, perhaps?

The mech that was in there was ID 0 (I downloaded the drive manual and
checked the jumpers).

-- 
"After the vintage season came the aftermath - and Cenbe."
Glenn Holmer  (Q-Link: ShadowM)  http://www.lyonlabs.org

       Message was sent through the cbm-hackers mailing list