silverdr_at_inet.com.pl
Date: 2008-02-01 22:20:21
Hello! I recall in the good old days, whenever I OPENed a file (of
course after SETLFSing and SETNAMming), I checked the status channel
to verify whether the file opened properly and I vaguely recall that I
was doing it because even if I expected OPEN to return some error
conditions, I always had problems with it and resorted to the status
channel. Do you know a better way to check for OPEN success/failure?
P.S. I was using C64/1541 but I believe the same is applicable to most
if not all CBM CPU/drive combinations
Message was sent through the cbm-hackers mailing list
Archive generated by hypermail pre-2.1.8.