From: Anders Carlsson (anders.carlsson_at_sfks.se)
Date: 2007-03-22 16:19:52
On Thu 2007-03-22 08:07, B. Degnan wrote:
> I have successfully replaced the 602s with an ST-225, but it's
> a 1/2 height drive which makes it hard to fit everything back
> into the chassis.
Hm. Isn't a half-height drive easier to fit than a full-height drive?
One of the 90X0 drives I picked up and sold last year was retrofitted
with a ST-225 if I recall correctly. It fit just below the controller
board and at a whole was slightly lighter than the Tandon 602S units.
I see from your blog that you needed taller risers to fit the ST-225.
In the four units I went though, I didn't notice any difference in
how the disks were secured.
A fun side note is that Seagate's website still has rudimentary
information about the ST-225, available through Google. However, if
you search by model number in their own system, nothing turns up. :)
--
Anders Carlsson
Message was sent through the cbm-hackers mailing list
Archive generated by hypermail pre-2.1.8.