r.lagendijk_at_hccnet.nl
Date: 2005-03-27 12:30:12
Hi Marko
It's a bit strange to ad a reset to a Oceanic drive but it's for a special project.
I looked at Ray Carlsen Webpage and there was a reset for the Excelerator +Plus drive. I found out that this almost the same and I could install the reset switch.
If you want to see my special project look here:
http://home.wanadoo.nl/richard.lagendijk/Html%20pagina/COMP-C-one-build.html
I hope the drive is not going to be a problem but it looks so good.
Greetings Richard
>> On Wed, Mar 23, 2005 at 08:43:23PM +0100, r.lagendijk@hccnet.nl wrote:
>
>> Hi,
>>
>>
>> Does anybody knows if it is possible to ad a reset switch to an Oceanic
>> OC118N diskdrive (1541 clone). If yes where do I connect the switch.
>>
>
> My first electronics project (some 18 years ago) was a reset switch built
> inside a serial bus DIN connector. I removed the flexible jacket from
> the end of the connector and mounted a push-button there. When pressed,
> the button should connect pins 2 and 6, if I remember correctly.
>
> Older C64s will be reset when you attach the button-connector to the free
> connector of the drive and push the button. Newer C64s won't reset, so
> there it'll only be a drive-reset.
>
> Of course, you can also build the switch inside the drive. But where are
> you going to mount the switch? The OC-118N has a very compact case, and
> it is pretty crowded inside.
>
> Marko
>
>
> Message was sent through the cbm-hackers mailing list
>
>
Message was sent through the cbm-hackers mailing list
Archive generated by hypermail pre-2.1.8.