ncoplin_at_orbeng.com
Date: 2002-12-04 03:42:17
Hi All,
I was doing some experimenting with a loader which installs in the $0b00
area on the C128 and should auto-execute if loaded with the BOOT"file",U11
command.
Indeed all works perfectly on the C128D and C128DCR machines that I have
tested, but on two flat C128's the code will not execute, instead a break
occurs and the monitor is entered. The code loads and looks fine.
In fact, LOAD"file",11,1 followed by a SYS11*256 works perfectly.
So, is this a know bug of the early C128 ROM (along with the CAPs-Q, etc) or
am I doing some thing wrong?
Any suggestions appreciated. The only thought I had was that the code needs
to be in the Track1 Sector0 format to BOOT on all machines.
- Nick
PLEASE TAKE NOTE:
The contents of this email (including any attachments) may be
privileged and confidential. Any unauthorised use of the contents
is expressly prohibited. If you have received this email in error,
please advise us immediately (you can contact us by telephone
on +61 8 9441 2311 by reverse charge) and then permanently
delete this email together with any attachments. We appreciate
your co-operation.
Whilst Orbital endeavours to take reasonable care to ensure
that this email and any attachments are free from viruses or other
defects, Orbital does not represent or warrant that such is explicitly
the case
(C) 2000: Orbital Engine Company (Australia) PTY LTD and its
affiliates
Message was sent through the cbm-hackers mailing list
Archive generated by hypermail 2.1.4.