From: Mikael Holm (mikael.holm_at_se.danskebank.com)
Date: 2002-10-03 09:30:32
Hi everybody...
I have a little question about the cassetteport on the C64. The plug on the
the end of the cable from the datasette only connects to the upper side of
the cassetteport. But on my C64 the metal on pin 1 on the upper side has
vanished (oxidation etc...) As this should be the power to drive the
cassette motor it rather difficult to to get a datasettem to run of this
port...
So my question is: Does the pins on the "down-side" of the cassette port
get the same set of signals as the upper counterpart? Then I could use the
down-side of the port to wire up a datasette...
Please share any and all thoughts
Regards,
Mikael
Message was sent through the cbm-hackers mailing list
Archive generated by hypermail 2.1.4.