RE: Problems with a long board 1541

• Previous message: Spiro Trikaliotis: "Re: Problems with a long board 1541"
• Maybe in reply to: Daniele Gratteri: "Problems with a long board 1541"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hallo Daniele,

> it turns on, 

I presume this means that the red LED lights up for a few seconds and then
goes out. Same for the motor, it turns for a few seconds and stops. If so
the computerpart most likely should be OK.

The first thing I would do is to replace the 7406 and 74LS14 you'll find
near IEC-connectors. These IC's buffer the signals from/towards the
computer. If these are brooken, the 1541 won't even "hear" the computer and
thus never will respond to any command at all.

    ___
   / __|__
  / /  |_/     Groetjes, Ruud
  \ \__|_\
   \___|       http://Ruud.C64.org

 

       Message was sent through the cbm-hackers mailing list

• Next message: Daniele Gratteri: "Re: Problems with a long board 1541"
• Previous message: Spiro Trikaliotis: "Re: Problems with a long board 1541"
• Maybe in reply to: Daniele Gratteri: "Problems with a long board 1541"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Archive generated by hypermail 2.1.4.