Re: Commodore 65 and DIN8 cable

From: Michał Pleban <*lists_at_michau.name*> Date: Fri, 29 Jan 2016 14:11:01 +0100 Message-ID: <56AB64E5.3070400@michau.name> · lists_at_michau.name

Hello!

silverdr@wfmh.org.pl wrote:

> I have a few SCSI HDDs and SCSI optical drives. In most cases the termination was done using socketed RPs aka RNs (resistor packs aka resistor nets). For mid-cable devices those were to be pulled out of their sockets. I can check those if you like too.

You're right, I pulled the MFM disk I used with the C900 and there is a
terminating resistor pack too, but I think only for on the MFM lines
because there are too few resistors to cover all control signals. Which
gives me another idea - measure these resistors, which could give some
estimate on how to rerminate the floppy MFM signals.

Regards,
Michau.

       Message was sent through the cbm-hackers mailing list