Re: LOAD command (Was: Disk drive questions)

From: Asbjørn Djupdal (Asbjorn.Djupdal_at_idi.ntnu.no)
Date: 2002-11-18 11:06:40

Next message: Nicolas Welte; address is valid for replies (Re:) only!: "Re: LOAD command (Was: Disk drive questions)"
Previous message: Marko Mäkelä: "LOAD command (Was: Disk drive questions)"
Maybe in reply to: Marko Mäkelä: "LOAD command (Was: Disk drive questions)"
Next in thread: Asbjørn Djupdal: "Re: Disk drive questions"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Marko Mäkelä <marko.makela@hut.fi> writes:

> On Sun, Nov 17, 2002 at 11:10:29PM -0500, William Levak wrote:
> > Even a simple LOAD or SAVE uses the command channel, although you normally
> > don't see it from BASIC.
> 
> Are you sure of this?  I thought LOAD would be equivalent to OPEN1,8,0,"FILE"
> and SAVE to OPEN1,8,1,"FILE".  I may remember the secondary addresses wrong.

I am quite sure that LOAD and SAVE does not open the command channel.

Asbjørn

       Message was sent through the cbm-hackers mailing list

Next message: Nicolas Welte; address is valid for replies (Re:) only!: "Re: LOAD command (Was: Disk drive questions)"
Previous message: Marko Mäkelä: "LOAD command (Was: Disk drive questions)"
Maybe in reply to: Marko Mäkelä: "LOAD command (Was: Disk drive questions)"
Next in thread: Asbjørn Djupdal: "Re: Disk drive questions"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Archive generated by hypermail 2.1.4.