Hallo Frank, > and 10V too. 18 V _and_ 10V: I start to understand why not many programmers supported it. Hallo Mia, > If you are looking for a second hand good quality programmmer ... I have this one: https://www.elnec.com/en/products/device-programmers/labprog-plus/ I want to start to tinker with the AtMega128 and just read that the LabProg+ probably won't support it. OTOH I bought a two dollar USB/ISP device usable for various AtMega device like the 644 and 1228 used by SD2IEC and similar devices. 999 Euro for its up-to-date successor is quite steep. Met vriendelijke groet / With kind regards, Ruud Baltissen www.Baltissen.org De informatie in dit e-mailbericht is vertrouwelijk en uitsluitend bestemd voor de geadresseerde. Wanneer u dit bericht per abuis ontvangt, verzoeken wij u contact op te nemen met de afzender per kerende e-mail. Verder verzoeken wij u in dat geval dit e-mailbericht te vernietigen en de inhoud ervan aan niemand openbaar te maken. Wij aanvaarden geen aansprakelijkheid voor onjuiste, onvolledige dan wel ontijdige overbrenging van de inhoud van een verzonden e-mailbericht, noch voor daarbij overgebrachte virussen. APG Groep N.V. is gevestigd te Heerlen en is ingeschreven in het handelsregister van de Kamer van Koophandel Limburg onder nummer 14099617 The information contained in this e-mail is confidential and may be privileged. It may be read, copied and used only by the intended recipient. If you have received it in error, please contact the sender immediately by return e-mail; please delete in this case the e-mail and do not disclose its contents to any person. We don't accept liability for any errors, omissions, delays of receipt or viruses in the contents of this message which arise as a result of e-mail transmission. APG Groep N.V. is registered in the trade register of the Chamber of Commerce Limburg, The Netherlands, registration number: 14099617Received on 2018-08-31 08:00:05
Archive generated by hypermail 2.2.0.