Hello, Ruud, have you installed the latest software for the ZoomFloppy? Have you updated the firmware? I seem to remember that old versions did not support IEEE-488 but with version 2.0 it works. Regards, Imre 2017-05-08 12:13 GMT+02:00 <Ruud@baltissen.org>: > Hallo allemaal, > > > After I bought my ZF I put it away and then it was lost for some > years. To make a long story short: I just happen to find it last > week. > > I installed everything according the site of Jim and the PDF. Things > work fine with my 1571. But the moment I disconnect the 1571 and > connect my 1001, CBMCTRL just says it is looking for drives and the > blue LED keeps flashing. Thinking it could be the error of CBMCTRL > because the help info only mentions the IEC bus, I tried D82COPY but > with the same result: a flashing LED. > > Did I miss something or am I doing something wrong? Any help is > welcome! > > > -- > > Kind regards / Met vriendelijke groet, Ruud Baltissen > www.Baltissen.org > > > > > > > > Message was sent through the cbm-hackers mailing list > Message was sent through the cbm-hackers mailing listReceived on 2017-05-08 12:00:03
Archive generated by hypermail 2.2.0.