Hello! silverdr@wfmh.org.pl wrote: > If you have valid schematics at hand, please check if those are only capacitors there. There might be other elements like Rs, FBs, ... Checking all of them under highly magnifying glass could sometimes reveal the cause too. I had a situation when an FB was seemingly intact but was in fact mechanically broken. When measuring, the pressure caused the problem to disappear but it became apparent when perusing under magnification and differently applied pressure. The schematic shows a box labeled "EMI", I don't know what that might be? http://www.zimmers.net/anonftp/pub/cbm/schematics/computers/C65%20Rev%202A%20Schematic.pdf Would it make sense to solder tiny wires to short each of these "EMIs" under the board? They could be unsoldered, returning the board to original state if required. Regards, Michau. Message was sent through the cbm-hackers mailing listReceived on 2016-03-02 17:00:10
Archive generated by hypermail 2.2.0.