silverdr-2 << I think I have come up with an even easier solution. I have managed to get a SFD-1001 (100i) with a smashed internal mechanism. It looks like it has been dropped on it's nose and it has caused the drive mech inside a fair bit of damage in the front end. However otherwise it's OK. Would you be willing to post me a couple of faulty internal drive mechs from a 8250LP? These are the same and would fit. Then maybe I could make a working one with a few spares for any future maintenance needs. The heads in these mechs are the fail point usually and it was where my original 8250LP from the 80's failed. I don't think this would be a lot postage wise to .AU? :) .-.-. ----- Ex CBM Outlet employee. In a parallel universe the world still runs on Commodore there is no IBM or Apple! ;) http://shazam.zapto.org .-.-. -- View this message in context: http://cbm-hackers.2304266.n4.nabble.com/Giday-from-Australia-tp4660196p4660218.html Sent from the cbm-hackers mailing list archive at Nabble.com. Message was sent through the cbm-hackers mailing listReceived on 2015-08-14 03:00:07
Archive generated by hypermail 2.2.0.