On 2013-07-20, at 16:57, Michał Pleban wrote: >>> or maybe you can have a PCB with different holes for different ROM spacings for only these two signals. >> And this is exactly what I plan to do for the next revision. > > Remember that you cannot solder all the pins anyway, because CHAR_CS pin > from the 1.0" version would fall on the CPU in the 0.8" board... I don't have to have all of them soldered in at the same time. I just want to have a single PCB for all of "three ROMs" mainboard variants. But there is a bigger problem. Three pins next to each other cause that I can no longer place the 28 pin socket with normal pads there. :-( When imagining the new version I in-head calculated that there was enough room but of course forgot the pads size. Seems that I'll have to either switch the pads to small ones (which I don't like) or rework the thing completely (which I don't want)... ;-) -- SD! Message was sent through the cbm-hackers mailing listReceived on 2013-07-20 20:00:18
Archive generated by hypermail 2.2.0.