On 06/07/2012 02:09 PM, email@example.com wrote: > Well, you can always use a brute force method, like cutting the +5V pin > - than anyone can do ;) That would be a bad idea. Most chips don't like it if the voltage on the signal pins is above the supply voltage (look under 'maximum ratings' in the data sheet). That can have all kinds of undesirable effects including destroying the chip. I give you that it works most of the time anyways. But 'works most of the time' is not a valid state for digital logic. ;) Gerrit Message was sent through the cbm-hackers mailing listReceived on 2012-06-07 13:00:31
Archive generated by hypermail 2.2.0.