Hallo Jim, > I spent this evening trying to augment my 2364 design to handle 2332 > and 2364, including 2364 with positive CS. Comments are appreciated: > > Schematic: http://postimage.org/image/2n6tytt8k/ Pin 21 from the 2332 must be used to generate the chip select for the eprom. Is that the wire to pin 2 of the 84hct86? If yes, this can be work. Only if the 2332 is programmed with on chip select at pin 21 or non chip select would be a problem. You can't disable the use of the chip select from pin 20, you can only programm the polarity. You need the jumper SJ3 for output enable (pin 22) of the eprom, too. Greetings Martin Message was sent through the cbm-hackers mailing listReceived on 2011-08-11 14:00:20
Archive generated by hypermail 2.2.0.