Hallo Steve, > ... the xtal at Y1 on my board is 15 MHz, not 12 MHz as indicated > on your GIF. It is Bo's board, so he can check it. And I doubt if I can change the schematic. It has been created using UltiSwitch/UltiBoard years ago. Even in the W98 era I had troubles starting it up under DOS, that is higher resolutions then 640*480. I already was thinking of making an Eagle version. But the lack of time.... :( -- ___ / __|__ / / |_/ Groetjes, Ruud \ \__|_\ \___| URL: Ruud.C64.org De informatie in dit e-mailbericht is vertrouwelijk en uitsluitend bestemd voor de geadresseerde. Wanneer u dit bericht per abuis ontvangt, verzoeken wij u contact op te nemen met de afzender per kerende e-mail. Verder verzoeken wij u in dat geval dit e-mailbericht te vernietigen en de inhoud ervan aan niemand openbaar te maken. Wij aanvaarden geen aansprakelijkheid voor onjuiste, onvolledige dan wel ontijdige overbrenging van de inhoud van een verzonden e-mailbericht, noch voor daarbij overgebrachte virussen. APG Algemene Pensioen Groep NV is gevestigd te Heerlen en is ingeschreven in het handelsregister van de Kamer van Koophandel Limburg onder nummer 14099617 The information contained in this e-mail is confidential and may be privileged. It may be read, copied and used only by the intended recipient. If you have received it in error, please contact the sender immediately by return e-mail; please delete in this case the e-mail and do not disclose it's contents to any person. We don't accept liability for any errors, omissions, delays of receipt or viruses in the contents of this message which arise as a result of e-mail transmission. APG Algemene Pensioen Groep NV is registered in the trade register of the Chamber of Commerce Limburg, The Netherlands, registration number: 14099617 Message was sent through the cbm-hackers mailing listReceived on 2010-12-06 07:00:09
Archive generated by hypermail 2.2.0.