1541 II Belt Drive

From: Scott <*rylos_at_charter.net*> Date: Sun, 11 Oct 2009 10:48:13 -0400 Message-ID: <000001ca4a81$dc168360$94438a20$@net> · rylos_at_charter.net

I've looked high and low for directions on alignment and setting the speed
on a 1541 II drive but have had no luck. 

I also have a 1541C that I can't find procedures for.  The 1541C has the PCB
(shorter board) with the long edge connector board (with surface mount
components sealed) mounted on the front of the PCB.

I built the Alignment jig to use with a Multi-meter but couldn't find where
to hook it to board. 

Any information would be greatly appreciated on these two drives. 

Thanks

---
avast! Antivirus: Outbound message clean.
Virus Database (VPS): 091010-0, 10/10/2009
Tested on: 10/11/2009 10:48:13 AM
avast! - copyright (c) 1988-2009 ALWIL Software.
http://www.avast.com

       Message was sent through the cbm-hackers mailing list