From: Jim Brain (brain_at_jbrain.com)
Date: 2008-12-04 07:07:46
Just a note that I received the initial shipment of uIEC/SD PCBs and it
appears I didn't make any glaring mistakes. I soldered one up and it
works.
A complete IEC-based hard drive in 2.25 sq inches (1.5x1.5)
This is the v3 family of designs, where the output for IEC lines is
buffered, meaning that the unit can play nicely on heavily loaded IEC
bus environments. As well, the PWR LED has been moved to an IO pin, so
it can be utilized for more than just power status in the future.
www.jbrain.com/vicug/gallery/uIEC/
Jim
--
Jim Brain, Brain Innovations (X)
brain@jbrain.com
Dabbling in WWW, Embedded Systems, Old CBM computers, and Good Times!
Home: http://www.jbrain.com
Message was sent through the cbm-hackers mailing list
Archive generated by hypermail pre-2.1.8.