From: Anders Carlsson (anders.carlsson_at_sfks.se)
Date: 2007-04-04 13:42:11
Attila Grósz wrote:
> I made a quick disassembly and it is not total garbage though.
If it helps, I might try to read them a few times more, perhaps
at a lower speed and confirm that I really get consistent output.
The fact it sets NTSC mode is in line with the channel switch on
the RF modulator.
Stupid question: assuming the board still works to the degree it
will give me a blank screen, will it work on a PAL TV if I tune
it to the right frequency? Perhaps in B/W or out of sync, but at
least something better than static? Of course I have composite
and separate video cables and a 1084 too.
Regards
--
Anders Carlsson
Message was sent through the cbm-hackers mailing list
Archive generated by hypermail pre-2.1.8.